Casket Lift Mounting Parts

Parts used for mounting the track on the Ultimate 1000 casket & body lift. These will include the track parts themselves, straight and curved sections, as well as the various parts needed for different uses. You will find track brackets, bumpers, gliders, trollies, hanger assemblies as well as track joints in this section.

A) LOAD BAR

Mortuary Lift

Part #RP-037

Required for FREEDOM PIVOT™ on stationary machines or curved track systems.
38” x 2-1/2”

B) THREADED RODS (1/2″x 20)

Mortuary Lift

Part #SP-021

Fully threaded rods can be cut to any length: cutting charges apply. May be obtained locally.

C) METAL FRAMING CHANNEL

Mortuary Lift

Part #SP-022

To be used when mounting track in the same direction as the ceiling joist. This channel is mounted at a right angle to the ceiling joist to disperse the weight load. Available in 10 foot sections. 12 Gauge – 1 5/8″ x 3 1/4″. May be obtained locally.

D) EXTRA LONG JOIST CLAMP

Mortuary Lift

Part #SP-012EL

Height of clamp 12″. Size of joist 2″. Inside width 1-7/8″. Size of side bolt holes 7/16″. Bottom hole 9/16″. First hole 1″ from top of bracket, each hole thereafter is 1-1/2″ on center from next hole. Weight 4 lbs.

E) EXTRA WIDE EXTRA LONG JOIST CLAMP

Part #SP-012EWXL

Height of clamp 12″. Size of joist 4″. Inside width 3-5/8″. Size of side bolt holes 7/16″. Bottom hole 9/16″. First hole 1″ from the top of bracket, each hole thereafter is 1-1/2″ on center from next hole. Weight 4 lbs.

F) “U” CLAMP

Mortuary Lift

Part #SP-014

End holes 7/16” diameter: Centers hole 9/16” diameter. Drop 2-3/16”. Height 2-1/8″.

G) ANGLE IRON

Mortuary Lift

Part #SP-023

Recommended for sway brace use. 1/8″ thick, 1-1/4″ leg length. 1 lb. per foot. 5′ lengths.